Common Failures In Onshore Oil & Gas Wells

Common Failures In Onshore Oil & Gas Wells

In the pursuit to further understand the challenges faced by oil and gas operators, Viking has maintained a failure database capable of determining common failures and failure trends. This information provides insight to aid in preventing common failures and improving industry practices to reduce incident rates in addition to saving time and money.

Failures Related to API 5CT High Strength Steels

American Petroleum Institute (API) 5CT high strength steels are extensively used for casing strings inwells subjected to high cyclic hydraulic fracturing loads. While non-sour grades of API steel such as P110 casing strings have been used satisfactorily for well construction, standard API P110 connections have seen higher rates of failures than pipe body failures in shale wells that require hydraulic fracturing.

Collapse Strength of Casing Subjected to Combined Load

Collapse Strength of Casing Subjected to Combined Load

Triaxial evaluation of wellbore loads is used extensively for casing and tubing string design and analysis. A triaxial based collapse strength method was recently adopted by the American Petroleum Institute (API), and an addendum issued to API Technical Report 5C3 (TR 5C3). The triaxial based collapse formula incorporates internal pressure and axial load into the calculation of casing and tubing collapse strengths.  Casing and tubing that are subjected to combined loads have higher collapse strength than previous formulas would predict, permitting the use of thinner walled, or lower strength, pipe than formerly required. 

Well Integrity: A Holistic Approach to Annulus Pressure Management for Subsea Wells

Annulus Pressure Management refers to an engineered approach ensuring that casing annulus pressures do not challenge the well’s integrity during the life of the well. The aim is to maintain the casing pressure within the well’s mechanical design limits at all times by controlling the ‘A’ annulus pressure. 

The ‘A’ annulus is the annular space between the production tubing and the first string of casing (i.e. production casing) as shown in Figure 1.  In subsea wells, the ‘A’ annulus is the only annulus that can be monitored and controlled.